Honeywell TESTAIR 4 Setup Manual page 9

4. Enter the Manufacturer Name and the Model
Name. Then select the units (Metric, Imperial or
Pascal), and select the type of apparatus (SCBA,
Airline Apparatus, SCBA/Airline or Facepiece).
5. Once the basic configuration of the apparatus is
entered, make sure that "Model Is Active" box is
selected and click "Next".
6. At the First Stage Selection screen Double Click
on the appropriate first stage connection from the
left column. The selection should then appear in
the right column.
In this example, we're configuring the first stage
for a 300 bar SCBA, so only first stages that can
be used with 300 bar are shown:

300 bar, No MP Connection

300 bar, MP Connection, No Max Rate

300 bar, MP Connection, Max Rate
Note: MP Connection stands for Medium Pressure.
For SCBA that are entered into the software with a
Medium Pressure connection in the Standard
software, the medium pressure readings will be
shown on tests where it is appropriate. The
Standard Software does not contain tolerances for
the medium pressure tests, so there will be no
indication whether the medium pressure portion of
the tests passes or fails.
All brand-specific versions of TestAir 4 Software
include Medium Pressure tests where appropriate (as
defined by the manufacturer). The inclusion of the
Medium Pressure connection allows the user to test
the output of the first stage according to the
manufacturer's specifications.
7. Once the selection is shown in the right column,
click "Next".
8. At the Regulator selection screen, double click on
the appropriate regulator from the Available
column so that it appears in the column at right.
9. Once the selection is shown in the right column,
click "Next".
10. Double click on the Facepiece from the Available
column so that it appears in the column at right.
Then click "Next".
EN-8