5.2 Switching on/off the AEG energy storage system
Switching on: open the door, and turn on the switches
of Load/Grid/Battery/Remote.
Turn off: Open the door, and turn off the switches of
Load/Grid/Battery/Remote.
Please refer to the below picture to locate the position
of the switches:
Item.
Description
1
PV switch
2
Grid breaker
3
Load breaker (remark: back-up load)
4
GEN breaker
5
Battery breaker
6
Remote switch
5.3 Operating the LCD touchscreen
LCD position
Item.
Description
1
Touchscreen LCD panel
AEG LOW VOLTAGE ENERGY STORAGE UNIT (4 kWH) INSTALLATION MANUAL
5.3.1 General remarks
Through the LCD display you will be able to monitor
the functioning of your AEG energy storage system and
adjust its settings. The LCD display gives you access to
a menu consisting of different sections, each featuring
sub-menus.
Some of the advanced settings need to be carried out
necessarily by the installer. These are explained in
detail in „5.4 Adjusting the settings - for installers only".
Some settings require the input of a password. The
default password is „12345".
When a sub-menu or a function requires the input of a
password, the following interface will be displayed:
Changing the parameters of the AEG energy storage
system will require confirming the operation as shown
in the below interface.
In the following section you will find detailed
information on each section and sub-menu, and how to
set the parameters of the AEG energy storage system.
20
EN
PD202107 V1-21