Table of Contents
Advertisement
Chemical replenishment
WARNING:
•
When changing chemical, be sure to carefully
wash the tank, pump, and nozzle, etc. with clean
water. Residue of the previous chemical may
cause a spray injury. Moreover, if chemicals mix,
a chemical change may occur, with the danger
of generating a toxic gas.
•
Be sure to wear protective gloves.
•
Do not change chemical in poorly ventilated
locale. (prevent chemical poisoning)
Check to make sure the sprayer switch is OFF and
replenish chemical tank with mixed chemical.
When filling tank with chemical, always strain chemical
through equipped tank strainer.
The side of the chemical tank is marked with scale divi-
sions, so be sure to use these as operation guidelines.
Firmly tighten chemical tank lid to prevent leaking.
Back strap adjustment
Adjust back strap to a length that brings the sprayer as
close to the body as feasibly possible.
Lengthening strap
(1)
Lift up buckle.
(2)
Pull the belt on the side connected to the sprayer.
1
2
► 1. Buckle 2. Lift up buckle 3. Pull
Shortening strap
Pull the belt on the free side.
1
► 1. Pull
3
NOTE: When shortening the strap, it will move rela-
tively easily if there is no weight exerted on the strap.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before attempt-
ing to perform inspection or maintenance.
•
For inspection and maintenance, always wear
protective gloves.
•
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
After-use maintenance
•
After use, remove residual liquid from chemical
tank, and wash away clinging chemical from inside
of tank using clean water.
•
Now fill up chemical tank with clean water and run
the sprayer for 2 to 3 minutes to wash out residual
chemical from the pump, hose, and nozzle, etc.
•
Remove the residual liquid from inside the chem-
ical tank, restart the pump, and run the sprayer
until residual liquid ceases to come out of the
nozzle, and then turn sprayer switch OFF.
•
Wipe away moisture and dirt from equipment, and
then check for damage and leaks.
Daily checks
•
Before work, check to see whether or not fastened
units are loose and components are missing.
•
Check to make sure the spray hose is not cracked,
worn and/or damaged.
•
After use, always be sure to wipe dirt off of exte-
rior, and to check for damage and/or leaks.
Cleaning water absorption strainer
1
► 1. Water absorption strainer
After removing chemical from tank, remove the water
absorption strainer at the bottom of the tank, and clean
it.
10 ENGLISH
Advertisement
Table of Contents
