Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Spray pipe and nozzle assembly
method
1
2
► 1. Spray pipe 2. lever cock 3. Nozzle
•
As shown in the figure, assemble spray pipe and
then nozzle onto lever cock.
•
Adjust direction of nozzle using nut on spray pipe.
•
Firmly attach components to ensure there is no
leaking.
•
Select nozzle according to type of spraying to be
done.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
3
NOTE:
•
All connector units use packing. Before assem-
bly, always check to see that the units have
packing.
•
Check to make sure that the spray hose is not
cracked, worn and/or damaged.
•
Firmly tighten on the spray pipe to prevent liquid
leaks.
•
If there is a leak from a connector unit, tighten
further using a hand tool (by approximately 45
degrees).
•
Do not use a spray pipe that is longer than the
standard one provided. Doing so may cause
leaking from connector units.
7 ENGLISH