Breville the Juice Fountain Cold Plus Instruction Book page 12

Motor appears to
stall when overload
protection LED flashes
Overload protection
LED light flashing
during the use
Overload Protection
LED is on
If any of the above issues persist, or if you have questions, stop use of the juicer and contact
Breville Consumer Support.
12
•
Wet pulp can build up under the juicer cover and stall the juicer if the
juicer is used excessively without cleaning. If this occurs, disassemble
and follow the cleaning instructions to clean the filter bowl surround, the
stainless steel filter basket and the juicer cover. The juicer can also stall
if excessive force is used to push produce down the feed chute. If this
occurs, ensure that a more gentle pressure is used to push produce down
the chute.
•
The juicer will automatically stop operating if too much food is being
processed at one time. Try processing a smaller amount per batch. To
continue juicing, reset the juicer by turning the juicer OFF and back ON.
•
Turn on the juicer before putting ingredients in the chute. Pressing
ingredients down before the juicer reaches full speed can cause the motor
to stall or overload. Use gentle to moderate pressure on the pusher. Lower
pressure produces a better juice yield.
•
Hard fruit and vegetables will put excess strain onto the motor if a low
speed is selected. Refer to the juicing guide to determine the correct
speed for the fruit and vegetables selected for juicing.
•
This indicates the motor speed is slowed down to an inefficient level.
This may be caused by excessive pushing force on the pusher or too
much pulp building up on the lid or in pulp pin. Use moderate pushing
force on the food pusher and regularly clean the lid and pulp bin to
ensure the juicer is operating at optimal speed.
•
This indicates motor overload protection is activated. To reset the unit,
turn the dial to OFF, unplug the juicer and let the motor cool down for
25–30 minutes, then plug the juicer back in.