Honeywell CNI4 Operating And Installation Manual page 36

9 Appendix
Ch Item #
4 - 1000 CF
5 - .1m3
6 - 1 m3
7 - 10 m3
8 - 100 m3
9 - 1000 m3
10 - 10000 CF
12 - 50 CF
13 - 500 CF
Ch1 Input Pulse Scaling
114
Ch2 Input Pulse Scaling
913
Default = 1.0000
000 Ch1 FixedFactor Volume
908 Ch2 FixedFactor Volume
Ch1 Inc FixedFactor
225 Volume
909 Ch2 Inc FixedFactor
Volume
Ch1 FixedFactor Value
044
Ch2 FixedFactor Value
440
Default = 0.0000
Ch1 Accumulated Vol
092
Units
090
Ch1 FixedFactor Vol
Item Name
Additional scaling for item 098 ans 912 (Input Pulse Value), if
required. Usually needed when the volume input is a value
other than 0.1, 1, 5, 10, 100, or 1000.
Totalized Accumulated Volume for Ch1 and Ch2, multiplied by
a user-assigned scaling factor provided by item 044 for Ch1
and item 440 for Ch2. The totalized value is then scaled to
the volume unit selected at item 090 for Ch1 and item 457 for
Ch2.
The number of digits is defined by item 096 for both.
The Incremental FixedFactor Volumes are the same as
FixedFactor Volume (item 000 and 908) but is initialized (re-
zeroed) at the beginning of every Log Interval (Hourly or
Daily) as definded by item 202. If the CNI4 is accessed via a
serial connection, this item will display the current value for
that point in time.
User-assigned scaling factor to be applied to the FixedFactor
Volumes for Ch1 and Ch2. The FixedFactor scaling is
normally used to adjust the accumulated volume for a fixed
pressure factor, a fixed temperature factor or both. The
scaling factors default to a value of zero, which forces the
FixedFactor Volumes to remain at zero when the fixed factor
feature is not used.
Codes (0-20) for item 092 (Accumulated Vol Units) and item
090 (FixedFactor Vol Units) that selects the volume units of
measure.
Description
Honeywell
| 33