Getting Started; Introduction - Honeywell CNI4 Operating And Installation Manual

7 Getting Started

7 Getting Started

7.1 Introduction

The CNI4 comprises of two components: The Pulse Accumulator and the Cloud Link 4G Modem.
You can use the MasterLink Software (R510.1 or higher) to configure the Pulse Accumulator and the
Cloud Link 4G Modem as two independent sites, using the USB-to-serial cable (40-6147-kit).
USB connection
One end of the cable has a USB connector and the other end includes a male and female connector. The
male (black) connector connects to the Cloud Link 4G Modem and the female (green) connector connects
to the Pulse Accumulator.
Steps to configure the CNI4:
Step 1: Open the door of the CNI4 and install the SIM
Step 2: Power-up the CNI4 - battery or external power supply.
Step 3: Connect the external pulse inputs (for wall mounted only)
Step 4: Disconnect the serial cable interfacing the Pulse Accumulator and the Cloud Link 4G Modem.
Step 5: Configure the Pulse Accumulator.
Step 6: Configure the Cloud Link 4G Modem.
Step 7: Restore the original serial cable connection.
Step 8: Close and lock the door.
Connector to the
Cloud Link 4G Modem
to the PC
Figure 7-1: The USB-to-serial cable (40-6147-kit)
Connector to the
Pulse Accumulator
Card.
Honeywell
| 14