Configuring The Pulse Accumulator - Honeywell CNI4 Operating And Installation Manual

7 Getting Started

7.6 Configuring the Pulse Accumulator

To configure the Pulse Accumulator
1. Insert the female connector of the Pulse Accumulator into the male connector of the USB-to-serial
cable (40-6147-kit).
2. Connect the USB end of the serial cable to a PC running the MasterLink R510.xx desktop
application.
3. Launch and login to the MasterLink R510.xx desktop application.
4. To select the COM port used by the USB-to-serial cable, navigate to the Settings menu, set the
baud rate to the recommended value (9600), and click OK.
5. Click Connect to connect to the Pulse Accumulator.
6. Close the warning pop-up, enter site name, and click Save.
7. Wait for the dashboard to load. Click the center of the Time Sync widget and perform a time
synchronization between the Pulse Accumulator and the PC by clicking Sync.
Honeywell
| 19