Single Zone Display; Status Display Of The Zones - Honeywell Esser 2 Series Operation And Installation Instruction

Extinguishing Control Computer 8010 - Series 2

12.1 Single Zone display

The status of the corresponding zone or of the output is shown with the 13 LED. The status of the 13 zones is
shown in normal operation.
With the key >Switchover<, it is possible to switch between indicating the zones or outputs.
Fig. 2: Zone displays

12.1.1 Status display of the zones

Detector zone no. 1 to no. 9 (yellow/red LED)
Off
Lights up red
Flashes red
Flashes yellow/red
Flashes yellow
On - yellow
Twinkle yellow
64
Detector zone
1 2 3
9 10 11 12 13
Fire/Switch off/Trouble
Normal operation, Detector zone ready to signal
Fire alarm of the detector zone no. 1 to 9
First alarm indicator, the first alarm was triggered by this zone
Test mode
Trouble, only restricted alarm readiness of the detector zone
Switch-off, the detector zone is switched off via the control panel
Input monitor, the zone number was entered via the control panel keypad
4 5 6 7 8
FB 798352 / 11.07