Resetting The Panel 8010; Lamp Test - Honeywell Esser 2 Series Operation And Installation Instruction

12.9 Resetting the panel 8010

The Extinguishing Control Computer 8010 can be reset via the function key of the control panel. For operation,
the keypad must be enabled via the key-switch. To restart the system press the appropriate button. The internal
panel status and all visual displays will be resetted.
For deactivated zones or zones in >Test mode< the restart does not take affect.
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Test operation
Un-
locked Extra releasing 1
Outputs
Alarm
Fig. 15: Operating example – panel reset

12.10 Lamp test

The lamp test can be carried out via the keypad. For operation, the keypad must be enabled via the key-switch.
All visual displays of the control panel lights up and the control panel buzzer is activated until the key is
released.
Lamp test
Un-
locked
Fig. 16: Operating example – Lamp test
FB 798352 / 11.07
Panel reset
In operation
Extinguishing system
enabled
Extinguishing system
activated
1
Emergency release
Switching off
Test operation
Extra releasing 1
Fire/Switch off/Trouble
Outputs
Alarm
Extinguishing Control Computer 8010 - Series 2
Detector zone
2 3 4 5 6 7 8
9 10 11 12 13
Common trouble
Emergency
operation
Power trouble
Battery trouble
Ground fault
Trouble 1
Blocking
75