Table of Contents
Advertisement
C-169
General Description
This feature enables a station, connecting to a second call while the station has been holding (consultation hold) an
original call (including ADD-ON CONFERENCE-8 PARTY [A-121] member), to disconnect the second call
forcibly by pressing DISC key for D
second call is released, and the original call is retrieved from hold. Situations available for this feature are as shown
below.
Situation 1:
When Station B is talking with
Station C while holding
(Consultation Hold) an original
call (Station A).
• Station A: Original Call
• Station B: Operating station for this
term
feature (D
PS)
• Station C: Second call called by Station
B (it can be disconnected by
this feature)
If a trunk for Three-Way
Note:
Calling within a MUX Card
is busy, this feature is not
available.
Procedure for Analog Station or PS
LC
Station A
(HOLD)
Station B
Station C
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Consultation Hold Release
Consultation Hold Release
term
once/going switch hook flash for analog station/PS twice. After that, the
Station A
(HOLD)
/Analog Station/
Station B
Station C
Three-Way Calling
Station A
Station B
Station C
(HOLD)
MUX
After station B goes
switch hook flash
Procedure for D
MUX
ELC
After station B presses
When station B presses CONF key before pressing DISC key,
THREE-WAY CALLING-D
MUX
ELC
After station B presses
CFT
Three-Way Calling
MUX
LC
Station A
Station B
Station C
CFT
term
Station A
DISC key
Station B
Station C
(ROT)
term
[T-2D] is established as shown below.
Station A
DISC key
Station B
Station C
(ROT)
Station A
After station B goes
switch hook flash
Station B
Station C
(ROT)
C-169
MUX
ELC
MUX
ELC
MUX
LC
Page 265
Advertisement
Table of Contents
