Video Input Connector [N] Visibility; Video Monitors; Video Output Connector [N] Cec Mode; Video Output Connector [N] Overscanlevel - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Video Input Connector [n] Visibility

n: 1..3
Define the visibility of the video input connector in the menus on the user interface.
Note that Connector 1 is the system's integrated camera, which is not available as a
presentation source.
Requires user role: ADMIN, INTEGRATOR
Default value: Connector 1: Never Connector 2: Always Connector 3: IfSignal
Value space: Connector 1: Never Other connectors: Always/IfSignal/Never
Always: The menu selection for the video input connector will always be visible on the
user interface.
IfSignal: Yhe menu selection for the video input connector will only be visible when
something is connected to the video input.
Never: The input source is not expected to be used as a presentation source, and will
not show up on the user interface.

Video Monitors

Define the monitor layout mode. Note that this video system supports only one screen, so
this value is fixed and cannot be changed.
Requires user role: ADMIN, INTEGRATOR
Default value: Single
Value space: Single
Single: The layout is shown on the video system's screen.
D15330.14 SX10 Administrator Guide CE9.7, APRIL 2019.
Configuration Peripherals Maintenance

Video Output Connector [n] CEC Mode

n: 1..1
This video output (HDMI) supports Consumer Electronics Control (CEC).
When this setting is On, the system will use CEC to set the screen in standby when the
system itself enters standby. Likewise the system will wake up the screen when the system
itself wakes up from standby.
Note that the different manufacturers uses different marketing names for CEC, for example
Anynet+ (Samsung); Aquos Link (Sharp); BRAVIA Sync (Sony); HDMI-CEC (Hitachi); Kuro
Link (Pioneer); CE-Link and Regza Link (Toshiba); RIHD (Onkyo); HDAVI Control, EZ-Sync,
VIERA Link (Panasonic); EasyLink (Philips); and NetCommand for HDMI (Mitsubishi).
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: CEC is disabled.
On: CEC is enabled.

Video Output Connector [n] OverscanLevel

n: 1..1
Some monitors may not present the entire image that they receive. This means that the
outer parts of the image that is sent from the video system may be cut off when displayed
on the monitor.
Use this setting to instruct the video system not to use the outer part of the available frame.
This part might be cut off by the monitor. Both the video and messages on screen will be
scaled in this case.
Requires user role: ADMIN
Default value: None
Value space: None/Medium/High
None: The video system will use all of the output resolution.
Medium: The video system will not use the outer 3% of the output resolution.
High: The video system will not use the outer 6% of the output resolution.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
158
Administrator Guide
System settings System settings Appendices