Networkservices Settings; Networkservices Cdp Mode; Networkservices H323 Mode; Networkservices Http Mode - Cisco TelePresence SX10 Quick Set Administrator's Manual

Hide thumbs Also See for TelePresence SX10 Quick Set:
Table of Contents

Advertisement

Cisco TelePresence SX10 Quick Set
Introduction

NetworkServices settings

NetworkServices CDP Mode

Enable or disable the CDP (Cisco Discovery Protocol) daemon. Enabling CDP will make the
endpoint report certain statistics and device identifiers to a CDP-enabled switch. If CDP is
disabled, the Network VLAN Voice Mode: Auto setting will not work.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The CDP daemon is disabled.
On: The CDP daemon is enabled.

NetworkServices H323 Mode

Define whether the system should be able to place and receive H.323 calls or not.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: Disable the possibility to place and receive H.323 calls.
On: Enable the possibility to place and receive H.323 calls.
D15330.14 SX10 Administrator Guide CE9.7, APRIL 2019.
Configuration
Peripherals
Maintenance

NetworkServices HTTP Mode

Define whether or not to allow access to the video system using the HTTP or HTTPS (HTTP
Secure) protocols. Note that the video system's web interface use HTTP or HTTPS. If this
setting is switched Off, you cannot use the web interface.
For additional security (encryption and decryption of requests and pages that are returned
by the web server), allow only HTTPS.
Note: The default value is HTTP+HTTPS for video systems that have been upgraded to
CE9.4 (or later) from an earlier software version, provided that the video system has not
been factory reset after the upgrade.
Requires user role: ADMIN
Default value: HTTPS (changed from HTTP+HTTPS to HTTPS in CE9.4)
Value space: Off/HTTP+HTTPS/HTTPS
Off: Access to the video system not allowed via HTTP or HTTPS.
HTTP+HTTPS: Access to the video system allowed via both HTTP and HTTPS.
HTTPS: Access to the video system allowed via HTTPS, but not via HTTP.

NetworkServices HTTP Proxy LoginName

This is the user name part of the credentials for authentication towards the HTTP proxy.
Requires that the NetworkServices HTTP Proxy Mode is set to Manual.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 80)
The authentication login name.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
118
Administrator Guide
System settings
System settings
Appendices

Advertisement

Table of Contents
loading

Table of Contents