When Adjusting The Image Quality Of The Black Mode - Toshiba e-STUDIO2010AC Imaging Manual

2.Copier-specific Adjustments
2.24.1

When adjusting the image quality of the Black mode

• Both the service technician and the user can perform step (1).
• Only the service technician can perform step (2).
(1) Press [Image] tab on the Copy mode and then press [ADF Noise Reduction].
Change the setting value of the noise reduction level.
Setting value
None
Low
Middle
High
After changing the setting value, perform printing and check its image quality.
If an additional image quality adjustment is necessary, perform the following steps.
(2) Enter [05 ADJUSTMENT MODE] and change the setting values for the codes from [7150] to [7152]
to adjust the noise reduction level.
Color mode Original mode
Text/Photo
Black
User Custom
• The smaller the value is, the larger the noise reduction level becomes. The larger the value is, the
smaller the noise reduction level becomes.
• When "0" is set for the setting value, this function becomes disabled.
After changing the setting value, perform printing and check its image quality.
 Caution after the adjustment
Nothing in particular
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Description
The noise reduction function is disabled.
The noise reduction level is low.
The noise reduction level is middle.
The noise reduction level is high.
[05] Code
7151
Text 7152
7150
2-96
Recommended value
Set a value smaller than
100.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Acceptable
Default
value range
0 to 200 100