To Suppress Color Misalignment - Toshiba e-STUDIO2010AC Imaging Manual

3.Printer-specific Adjustments
3.16

To Suppress Color Misalignment

Before adjustment
 Explanation
White voids in the background caused by off-registration of the text or graphics can be reduced and color
misalignment can be suppressed by the Auto Trapping adjustment. Use this mode if the effectiveness of
the color misalignment correction is to be enhanced.
 Procedures
The service technician must perform all adjustments.
Enter [05 ADJUSTMENT MODE] and change the setting value for the code [8244]. First, change the
setting value of the subcode 0. Only when the effect is insufficient even if the setting value of the
subcode 0 is changed to "3", alter the one for the subcode 1.
Color mode Adjustment
Trap width (dot)
Auto/Color
Trap density
*1 When a larger value is set, it will get stronger against a wider gap (off-registration); however,
overlapped areas will become more conspicuous.
*2 The smaller the value is, the darker the boundary color becomes. In this case, the gaps will not
become conspicuous; however, overlapping areas will become more conspicuous.
• The above setting will be referred to when [Auto Trapping] on the printer driver has been enabled.
[Auto Trapping] is enabled as the default.
 Caution after the adjustment
Perform the adjustment while checking the images, since the outline form of the boundary of the text or
graphics will be accentuated if the effectiveness of the trapping is enhanced.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
[05] Recommended
Subcode
Code
Set the value to 3
8244 0
Set the value smaller
8244 1
than 128 (*2)
3-128
After adjustment
Acceptable
value value range
1 to 3
(*1)
0 to 255
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Default
2
128