Honeywell FF-SPS4 Series Installation Manual page 45

Safety perimeter guarding

Table of Contents

Use of individual deflection mirrors FF-SPZ

Each mirror is delivered with a target drawn on an adhesive paper (the electrostatic process guarantees

the cleanliness of the mirror). For a quick infrared beam alignment, follow the following procedure:

Install the brackets, the sensors and the mirror(s) without tightening the screws, and supply the

units with the correct power to supply the front panel indicators (refer to § 6.2 and § 6.3).

Put the laser pen in the location notch of the emitter unit. The two positioning rings should rest in

the location notch.

Adjust the position of the mirror(s) in such a way that the laser beam deflection occurs in one of

two holes of the target (ø 20 mm hatched zones in the above figure). The mirror(s) adjustment

must be carried out in such a way that the returned laser red spot appears on the front face of the

receiver unit (hatched areas above or below the receiver lens as shown on the above figure).

Repeat the same operations with the laser pen on the receiver unit.

Secure the adjustment by tightening the screws.

In addition to this laser pen accessory, the equipment is featured with indicators on the front panel

which provides usefull indication for alignment step.

Arrow.com.

Downloaded from

MIR

107063-11 EN FR26 GLO 800 Printed in France

Table of Contents

Show Quick Links

Table of Contents

Ff-sps42tre Ff-sps42trg Ff-sps44cre Ff-sps44crg Ff-sps44cr2 Ff-sps44tre ... Show all