Siemens SINUMERIK 840D sl Series Diagnostics Manual page 451

08/2005
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61139
Channel %1 block %2: error in function tool monitoring in cycles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61175
Channel %1 block %2: angle of aperture _DF programmed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The angle of aperture of the text in the engraving cycle is too small. This means that the
text for engraving does not fit in the specified angle.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter a larger angle of aperture.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61176
Channel %1 block %2: text length _DF programmed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The text length in the engraving cycle is too short. This means that the text for engraving
is longer than the specified text length.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter longer text length
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61177
Channel %1 block %2: polar text length > 360 degrees
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the engraving cycle, the polar text length must not exceed 360 degrees.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-451