Siemens SINUMERIK 840D sl Series Diagnostics Manual page 294

Hide thumbs Also See for SINUMERIK 840D sl Series:
Table of Contents

Advertisement

Overview of Alarms
Definitions:
The maximum number of symbols defined by machine data 28020
MM_NUM_LUD_NAMES_TOTAL has been exceeded.
Reactions:
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
Please inform the authorized personnel/service department.
• Modify machine data
• Reduce the number of symbols (variables, subroutines, parameters)
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
17001
Channel %1 block %2 no memory left for tool/magazine data
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
The number of the following tool/magazine data sizes in the NC is given by machine data:
• Number of tools + number of grinding data blocks: 18082 MM_NUM_TOOL
• Number of cutting edges: 18100 MM_NUM_CUTTING_EDGES_IN_TOA
Tools, grinding data blocks, cutting edges can be used independently of the tool manage-
ment function.
The memory for the following data is available only if the corresponding bit in 18080
MM_TOOL_MANAGEMENT_MASK has been set.
• Number of monitoring data sets: 18100 MM_NUM_CUTTING_EDGES_IN_TOA
• Number of magazines: 18084 MM_NUM_MAGAZINE
• Number of magazine locations: 18086 MM_NUM_MAGAZINE_LOCATION
The following size is determined by software configuration: Number of magazine spacing
data blocks: P2 permits 32 such spacing data blocks.
Definition:
• 'Grinding data blocks': Grinding data can be defined for a tool from type 400 to 499.
Such a data block occupies additional memory, as it is planned for a cutting edge.
• 'Monitoring data blocks': Each cutting edge of a tool can be supplemented by monitoring
data.
• 'Magazine spacing data block': Spacings to other magazines can be defined for maga-
zine locations in internal magazines.
Reactions:
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy:
Please inform the authorized personnel/service department.
• Modify machine data
• Modify the NC program, i.e. reduce the number of items related to the variable which
caused the error condition.
Program Con-
Clear alarm with NC START or RESET key and continue the program.
tinuation:
17010
Channel %1 block %2 no memory left
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
When executing/reading files from the active working memory, it was found that there is
not enough memory space (e.g. for large multidimensional arrays or when creating tool
offset memory).
Reactions:
- Interpreter stop
2-294
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005

Advertisement

Table of Contents
loading

Table of Contents

Save PDF