Siemens SINUMERIK 840D sl Series Diagnostics Manual page 563

08/2005
Remedy: Place the cursor on the tool.
104001
No additional tools available
Definitions: After pressing the softkey "T No. +" or "T No. -" the next-highest or next-lowest tool num-
ber is searched for.
If no other tools are available, this message will be output.
Remedy: --
104002
No additional tool edges available
Definitions: After pressing the softkey "D No. +" or "D No. -" the next-highest or next-lowest cutting
edge is searched for.
If no other cutting edges are available, this message will be output.
Remedy: --
104003
There are no tools
Definitions: No tools were set up.
Remedy: Set up tools.
104004
No active workpiece available
Definitions: After pressing the softkey "Current T+D No." in the "Tool overview" window, no tool was
found because no subroutine is active or in the active subrutine no tool is selected.
Remedy: Select a tool.
104005
There is no active cutting edge
Definitions: A tool has been selected, but not a cutting edge.
Remedy: Select a cutting edge.
104006
No TO area available in current channel
Definitions: No TO area is assigned to the current channel.
Remedy: Assign the current channel a TO area via the machine data, or switch channels.
104007
Error on creating tool
Definitions: The tool could not be created, as, for example, the maximum number of possible tools
has already been reached.
Remedy: Extend the maximum number of tools via the machine data, or delete unnecessary tools.
104008
Error on creating tool edge
Definitions: No new cutting edge could be created, as, for example, the maximum number of cutting
edges has already been reached.
Remedy: Delete unnecessary cutting edges.
104009
Error while writing tool type
Definitions: --
Remedy: --
104010
Error while writing tool position
Definitions: --
Remedy: --
104011
Error on deleting tool
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-563