Siemens SINUMERIK 840D sl Series Diagnostics Manual page 932

Overview of Alarms
Parameters: %1 = Axis
%2 = Fault code of drive (P824)
%3 = Fault value of drive (P826)
%4 = Fault time of drive (P948/P825)
Definitions: Contents of fault memory of assigned drive.
Reactions: - Alarm display.
Remedy: See drive documentation for fault codes/fault values.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
380501
PROFIBUS DP: fault on bus,slave %1, code %2, value %3, time %4
Parameters: %1 = 8 bit high = bus number 8 bit low = slave number
%2 = Fault code of drive (P947)
%3 = Fault value of the drive (P949)
%4 = Fault time of the drive (P948)
Definitions: Contents of the fault memory of the assigned slave.
Reactions: - Alarm display.
Remedy: See drive documentation for fault codes/fault values.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
380502
PROFIBUS DP: bus %1, slave %2 configuration changed
Parameters: %1 = Bus number
%2 = Slave address
Definitions: The PB bus configuration has changed.
Causes:
• Initial start-up
• New PB slave recognized on the bus
Reactions: - Interface signals are set.
- Alarm display.
Remedy: In order to operate the bus with the new configuration, an additional restart will be
required.
Program Con- Switch control OFF - ON.
tinuation:
380503
PROFIBUS DP: bus %1 configuration changed
Parameters: %1 = Bus number
Definitions: A new SDB2000 with a modified configuration was provided.
The new settings will be activated only at the next ramp-up of PROFIBUS.
Reactions: - Interface signals are set.
- Alarm display.
Remedy: In order to operate the bus with the new configuration, an additional restart will be
required.
Program Con- Switch control OFF - ON.
tinuation:
400102
Delete DB 2 in the PLC and restart
Definitions: The DB created by the basic program and the existing DB differ in size.
Reactions: - Alarm display.
2-932
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005