Installation Instructions - Cisco ONS 15454 Unpacking And Installing

Installation Instructions

The emphasis in the following installation instructions is to remove the Bay Assembly from its shipping
pallet and position it in your facility. Perform actual installation and individual node provisioning
according to local site practice.
Install the Four-Shelf and Zero-Shelf Bay Assembly
Line the hand truck with a utility blanket or an equivalent type of protection.
Step 1
Position the safety hand truck so that it faces the front (door side) of the Bay Assembly.
Step 2
With one person on each side of the Bay Assembly and one manning the hand truck, position the blade
Step 3
of the hand truck under the edge of the rack.
Secure the safety strap snugly around the Bay Assembly.
Step 4
Do not cinch the strap too tightly. Cinching the strap too tightly can result in component damage.
Extend the outrigger wheels from the hand truck.
Step 5
With one person on each side of the Bay Assembly, gently tilt the Bay Assembly until the outrigger
Step 6
wheels on the safety hand truck are firmly on the floor.
Move the Bay Assembly to the installation site and unload it from the safety hand truck.
Step 7
To avoid injury, make sure that a sufficient number of people are present.
Install the Bay Assembly according to local site practice.
Step 8
For more information about installing or configuring individual Cisco ONS 15454s, refer to
Cisco ONS 15454 user documentation.
After the rack is installed attach the extender bases and vertical extenders to both sides of the rack.
Step 9
a.
b.
78-13271-05
Attach the two extender bases to each side of the rack using the hardware supplied with the extender
bases.
Attach the two vertical extenders to each side of the rack using the hardware supplied with the
vertical extenders.
Unpacking and Installing the Cisco ONS 15454 Four-Shelf and Zero-Shelf Bay Assembly
Installation Instructions
7