Switching On And Off; Working With The Implement - Grizzly ERV 1801-37 ZV Translation Of The Original Instructions For Use

-3 mm: Working position
Set this position when working with a new
implement.
-3 mm to -12 mm: Readjustment posi-
The working position can be lowered with
increased knife and sprung tine wear.
Wear can be identified from an increas-
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting.
When the implement is delivered it
is in the Transport Position setting
+10 mm.
1. The implement must be switched off to
set the working position.
2. Adjust the depth adjustment lever
( A 10) and allow it to lock into place
in the desired position.
Selection of a readjustment posi-
tion without the corresponding
wear can overload the motor and
damage the cylinder.
D

Switching on and off

Before switching on the imple-
ment ensure that it is not in
contact with any objects. Keep
your feet and hands well away
from the cylinder and the ejector
opening. Danger of injury!
1. Place the implement on a level lawn
surface.
2. Connect the extension cord to the ap-
pliance socket (18).
3. Form a loop in the end of the power
cable and hang it into the strain relief
(14).
tions
4. Connect the implement to the mains
voltage.
5. To switch on, press the electronic
switch lock (1) on the handlebar and
then pull the start handle (2) towards
the handlebar. Release the electronic
switch lock (1).
6. To switch off release the starting lever
(2).
Overload protection: The motor
is automatically switched off when
the implement is overloaded. Re-
lease the starting lever and reset
the implement after a cooling down
period of approx. 1 minute.
WARNING! The cylinder con-
tinues to run for a brief period
after the implement has been
switched off. Do not tilt or carry
the implement while the motor
is still running and do not touch
the cylinder while it is still rotat-
ing. Danger of injury!

Working with the implement

To maintain a well cared-for lawn it should
be aerated every 4 to 6 weeks.
Verticuting is a more intensive intervention
than aerating and should only be carried
out once a year, the best time being in
spring after the lawn has been mown for
the first time.
When working on slopes always
proceed across the slope. Be
particularly careful when walk-
ing backwards and pulling the
implement. Danger of stumbling!
After work and to transport the im-
plement disconnect the power plug
GB
29