Parts Description - Makita DVC860L Instruction Manual

The suction power can be adjusted according to your
work need.
Suction power can be increased by turning the suc-
tion force adjusting knob from the
the symbol.
NOTICE:
• Always set the stand-by switch to the "O" side
when not using the cleaner for long time. The
cleaner consumes power during stand-by state.
Auto-suction stop during wet
suction operation (for the cloth filter
model)
WARNING:
• Do not use for a long time while the float is at
work. Using the cleaner with its float at work for
a long time can cause overheat, resulting in the
cleaner deformation.
• Do not pick up foam or soapy liquid. Picking
up foam or soapy liquid can cause foam to come
out of air exit before the float works. Continuing
to using in this condition may cause an electric
shock and breakage of the cleaner.
Auto-suction stop works only when using with the float
and float cage.
The cleaner has a float mechanism that prevents water
from immersing into the motor when picking up more
than a certain amount of water.
When the tank is full and the cleaner no longer picks up
water, switch off the cleaner and empty the tank.
Locking or unlocking the caster
► Fig.9: 1. Caster 2. Stopper lever 3. FREE position
4. LOCK position
To lock the caster with a stopper, lower the stopper
lever and the caster no longer will rotate. To release the
caster from the locked position, raise the stopper lever.
Locking the caster is convenient when storing the
cleaner, stopping the work on the way and keeping the
cleaner still.
To operate the stopper, move it by hand.
NOTE:
• When moving the cleaner, make sure that the
caster is unlocked. Moving the cleaner with the
caster in the locked position may cause damage
to the caster.
Carriage handle
► Fig.10
When carrying the cleaner, carry it by holding the han-
dle on the head. The handle is retractable at the head
when not in use.

PARTS DESCRIPTION

symbol to
Model DVC860L
(Cloth filter (for dry and wet dust) model)
► Fig.11: 1. Tank cover 2. Float 3. Float cage 4. Cloth
Model DVC861L
(Powder filter (for dry dust) model)
► Fig.12: 1. Tank cover 2. Powder filter (HEPA)
ASSEMBLY
•
•
Installing the powder filter (HEPA)
and prefilter (for dry dust)
Optional accessory for cloth filter model
•
► Fig.13: 1. Tank cover 2. Powder filter (HEPA)
► Fig.14: 1. Float 2. Float cage
To use powder filter, remove the float cage and float by
removing the bolts.
Place the prefilter in the tank.
Next, mount the damper on the powder filter and then
place them in the prefilter.
When installing powder filter and prefilter, align the
mounting position marking on each of them with that
one at the top of the tank.
Finally, mount the tank cover and lock it.
NOTE:
•
11 ENGLISH
filter 5. Tank
3. Damper 4. Prefilter 5. Tank
CAUTION:
Always be sure that the cleaner is switched off,
unplugged, and the battery cartridge is removed
before carrying out any work on the cleaner.
Always wear dust mask during assembly or
maintenance.
CAUTION:
Never pick up water or other liquids or wet dusts
when using the powder filter. Picking up such
things may cause the powder filter breakage.
3. Damper 4. Prefilter 5. Tank 6. Mounting
position marking
Before using the powder filter, make sure that
prefilter and damper are always used together. It
is not allowed to install powder filter solely.