Table of Contents
Advertisement
phase adjustment is necessary.
(Adjustment Procedures)
1. Install a MIC Intermittent Gear.
2. Set the Reel Rotor Unit at M Cassette Position by hand.
3. Install a MIC Drive Arm Unit.
4. Rotate the MIC intermittent Gear by hand so that the Distinction
SW is as close as possible.
5. Install a Reel Drive Cam Gear so that the its hole is at MIC
intermittent gear hole.
6. Install 3 cut washers (A), (B) and (C).
Adjustment Note:
1. Close the Reel Table to M Cassette position.
2. Set the MIC SW (Distinction SW) to the nearest position from the
Reel.
3. MIC Drive Arm Unit Pin position is as shown in the above figure.
4. Reel Drive Came Gear Hole and MIC Intermittent Gear phase are
matched.
5.7.29. T4 Post Position Adjustment
1. Set the VTR unloading condition.
2. Confirm the T4 post hole is at the T4 connection gear (B).
3. Confirm that (c) and hole (A) position is as shown in the figure.
4. If the T4 post position is incorrect adjust following procedures.
Gear Position
78
Advertisement
Chapters
Table of Contents
