Table of Contents
Advertisement
3-7-19. T1 Boat Unit Replacement
(Removal of T1 Boat Unit)
1.
Remove the top panel.
2.
Remove the front loading unit.
3.
Remove the screw (C) and remove the T1 Post from
the Loading Rail.
4.
Remove the T1 Boat Unit from the T1 Loading Arm
Unit.
(Installation of T1 Boat Unit)
1.
Install a new T1 Boat Unit as reverse order of its
removal.
2.
After its installation, confirm the T1 Post moves on
the Loading Rail. Then Linearity Adjustment is
necessary.
3-7-20. T1 Loading Arm Unit Replacement
and Adjustment
(Removal of T1 Loading Arm Unit)
1.
Remove the top panel.
2.
Remove the front loading unit.
3.
Remove the cylinder unit. (Refer to the cylinder unit
replacement.)
4.
Rotate the emergency eject shaft CW to load the T1
Post and make a space to remove the screw (D) as
shown in Fig. 6-15-1.
5.
Remove the screw (A) and (C) then remove the S1
and T1 Posts from the Loading Rail.
6.
Remove the screw (D) and (E) and remove the
Loading Rail.
7.
Remove the T1 Boat Unit from the T1 Loading Unit.
(Installation of T1 Loading Arm Unit)
1.
Install a new T1 Loading Arm Unit as reverse order
of its removal. For this installation the following
adjustment is necessary.
(Adjustment Procedures)
1.
Install T1 Loading Arm Unit so that the Hole (A) and
Hole (B) are in parallel.
2.
After installation, confirm that the T1 post moves
smoothly on the Loading Rail. Then Linearity
Adjustment is necessary.
T1 Loading Arm Unit Position Adjustment
3-7-21.Cleaner Solenoid Replacement and
Adjustment
(Removal of Cleaner Solenoid)
1.
Remove the top panel.
2.
Remove the Front Loading Unit.
3.
Remove the connector P11 on the Mechanical
Interconnection Board.
4.
Remove two screws (A) and remove the Cleaner
Solenoid Unit.
5.
Remove two screws (B) and remove the Cleaner
Solenoid.
(Installation of Cleaner Solenoid)
1.
Install a new Cleaner Solenoid as reverse order of
its installation.
2.
After its installation adjust Cleaner Solenoid
Position.
Advertisement
Chapters
Table of Contents
