Honeywell ESSER IQ8Control C Installation Instruction page 6

Fire Alarm Control Panel IQ8Control C / M
tools 8000 service and programming software
The commissioning and configuration of the fire alarm system requires the use of the tools 8000 service and
programming software.
Depending on the software and system-specific customer data programming of your panel, its
functions and display characteristics might differ from the ones described in this manual! The terminal
connections and connections shown in this installation manual relate only to the specifications for the
panel operating system software for the Federal Republic of Germany [D].
GNU Licence (GPL)
The firmware integrated in this product contains copyright protected third party software, which was licensed under
the GPL (GPL software). The following applies in accordance with the GPL:
1. The source code for the GPL software can be downloaded from www.esser-systems.com.
2. The GPL software can be reused, forwarded and modified.
3. The GPL software alone shall be provided to the extent permitted by law without liability for defects and
without any express or implied guarantee, including that of the capacity to act or suitability for a specific
purpose.
4. A copy of the GPL can be viewed and downloaded at www.esser-systems.com. Please use the contact form
on the website for potential queries and additional information.
Open source software – information
The FACP IQ8Control C/M contains open source software subject to modified (2-clause, 3-clause) BSD licenses.
For further information refer to the documentation Open Source Information - FACP IQ8Control
(Part No. 798952).
6
FB 798951.10.GB0 / 04.15