Table of Contents
Advertisement
Chapter 6 — Maintain the Printer
Adjust the Printhead Balance
The printhead is adjusted for full-width media. If you are using media that
is less than full-width (4 inches or 102 mm), adjust the position of the
printhead balance arm so that the printhead is correctly pressured
against the media.
1 Open the media cover.
2 If you have ribbon installed, remove the ribbon.
3 Turn the printhead lift lever counterclockwise to raise the printhead.
4 Press down on the blue part of the printhead balance bar and move
5 Close the printhead and load the ribbon.
6 Test and readjust the printhead balance if necessary.
7 Close the media cover.
70
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
it:
•
outward for wider media.
•
inward for narrower media.
V10 CONSUMIBLES S.L.
PM42 Industrial Label Printer User Manual
Advertisement
Table of Contents
