Table of Contents
Advertisement
3 Load a media roll onto the media supply hub. Make sure you push
4 Route the media through the print mechanism.
5 Adjust the printhead balance. For help, see
6 Turn the printhead lift lever clockwise to close the printhead.
7 Adjust the label gap and black mark sensor. The sensor LED should
8 Close the media cover.
9 Press the Print button to advance the media.
10 Configure the printer for the correct media type (media with gaps,
11 Calibrate the sensors:
12 Configure the start and stop adjust settings.
PM42 Industrial Label Printer User Manual
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
the roll all the way against the inner wall of the printer and adjust the
edge guide and the dancer guide to hold the media in place.
Balance" on page
70.
line up with the center of the media. For help, see
Gap and Black Mark Sensor" on page
black mark, continuous fixed length, or continuous variable length).
•
From the printer Main Menu select Wizards > Calibration >
Media.
•
From the printer web page select Services > Media Calibration.
V10 CONSUMIBLES S.L.
Chapter 2 — Set Up the Printer
"Adjust the Printhead
"Adjust the Label
72.
17
Advertisement
Table of Contents
