Printhead Assembly - Honeywell PC42d Service & Repair Manual

TITLE
PC42d Service Repair Manual

Printhead Assembly

OPERATION:
Carefully pull the latching tabs holding the printhead to the chassis assembly and grounding screw.
Tools Required
Description
Phillips Screw Driver
Parts Required
Item Part Number
1 50131325-001FRE
2 50130017-001FRE
3 50130720-001FRE
Printhead Assembly Removal
1. Remove the printhead by releasing the printhead latches on both side. See Figure 5.
2. Remove the printhead ground screw securing the printhead assembly to chasis ground. See Figure 6.
Figure 5 – Printhead Removal
Printhead Assembly
Printhead Assembly Installation
1. Install in reverse order
2. Tighten printhead grounding screw to grounding scew to 6±0.3kfg/cm.
Model
PC42d
Description
FRE, Assy, TPH Module, PC42d
FRE, Spring, TPH, 50-Pack
FRE, Cable, TPH and Ground
1
DOCUMENT NO.
L3-GLBL-RPR-4260
(Rev A)
Figure 6 – Printhead Ground Screw
2
Printhead Spring
PAGE
Page 11 of 25
Printhead Cable
L3-GLBL-RPR-4260 (Rev A)
Qty
1
1
3