Lubrication - Grizzly G9972Z Owner's Manual

Lubrication

Your lathe has numerous moving metal-to-metal
contacts that require proper lubrication to help
ensure efficient and long-lasting operation.
Other than the lubrication points covered in this
section, all other bearings are internally lubricated
and sealed at the factory. Simply leave them
alone unless they need to be replaced.
Before adding lubricant, clean away any debris
and grime from the lubrication point to avoid con-
taminating the lubricant and increasing wear of
the moving parts.
DISCONNECT THE LATHE FROM POWER
BEFORE PERFORMING LUBRICATION!
Ball Oilers
Lubricant Frequency
ISO 68 or Every 8 Hours
Equivalent of Operation
Lubricant
Wipe clean and lubricate the ball oilers shown in
Figures 74–78. To insert the oil, depress the ball
with the tip of an oil can and squirt once.
Figure 74. Change gear ball oilers.
NOTICE
Follow reasonable lubrication practices as
outlined in this manual for your lathe.
Failure to do so could lead to premature
failure of your lathe and will void the war-
ranty.
Model G9972Z (Mfd. Since 03/20)
Qty
1 squirt
from Oil
Can
2 Ball Oilers
2 Ball Oilers
Figure 75. Spindle bearing ball oilers.
Figure 76. Apron ball oilers.
Figure 77. Cross slide ball oilers (one in view).
2 Ball Oilers
Figure 78. Tailstock quill and leadscrew ball
oilers.
4 Ball Oilers
3 Ball
Oilers
-51-