Grizzly G9972Z Owner's Manual page 33

To offset the tailstock:
1. Loosen the tailstock lock nut (see Figure 29).
Tailstock
Lock Nut
Adjustment
Set Screw
(1 of 2)
Figure 29. Left offset adjustment.
2.
Rotate the adjustment set screws in opposite
directions for the desired offset (see the illus-
tration in Figure 30).
Turn
Turn
CCW
CW
Figure 30. Set screw adjustment in relation to
tailstock movement.
3. Retighten the tailstock lock nut to secure the
offset.
Model G9972Z (Mfd. Since 03/20)
Offset
Indicator
Turn
Turn
CCW
CW
Aligning Tailstock to Spindle
Centerline
This is an essential adjustment that should be ver-
ified or performed each time the tailstock is used
to turn concentric workpieces between centers
or immediately after offsetting the tailstock when
turning a taper. If the tailstock is not aligned with
the spindle centerline when it is supposed to be,
turning results will be inaccurate along the length
of the workpiece.
Items Needed
Hex Wrench 4mm .............................................. 1
Open-End Wrench 19mm .................................. 1
Round Stock 2" x 6" .......................................... 2
Precision Level .................................................. 1
Precision Calipers ............................................. 1
Dial Indicator ..................................................... 1
To align the tailstock to the spindle centerline:
1.
Use the precision level to make sure the
bedway is level from side-to-side and from
front-to-back.
— If the bedway is not level, correct this con-
dition before continuing (refer to Leveling
& Mounting on Page 17).
2.
Center drill both ends of one piece of round
stock, then set it aside for use in Step 5.
3. Use the other piece of round stock to make
a dead center, and turn it to a 60° point, as
illustrated in Figure 31.
Figure 31. Turning a dead center.
Qty
-31-