Overview; Chassis Packaging - Cisco NCS 4000 Series Manual

Overview

This chapter provides pertinent information that you should know about the Cisco NCS 4016 chassis before
unpacking and moving it into a rack.
The Cisco NCS 4016 chassis contains two slots for route processor (RP) cards, sixteen slots for line cards
(LC), and four slots for fabric cards (FC). The Cisco NCS 4016 chassis is rack mountable. It is compatible
with the following standard rail spacing:
• ANSI 19-inch or 23-inch (2 or 4-post)
• ETSI
For the ANSI 19-inch rack, the minimum front opening must be 17.72 inches (450 mm) to allow for
Note
chassis insertion.
•
•
•

Chassis Packaging

The Cisco NCS 4016 chassis arrives on the primary system pallet with a label that describes the contents.
Cards are shipped on a separate card pallet. The complete details on the contents of each pallet reflect the
customer's sale order, which is reported on the parts identification label on the pallet or shipping manifest.
The primary system pallet contains the chassis, which is covered with a corrugated master shipper packing
crate held together with plastic bands.
The chassis is shipped with the following components already installed:
• Fan trays
• Power trays (AC or DC)
• Power modules
Chassis Packaging, page 1
Verifying the Securing Location, page 2
Safety Guidelines, page 3
Cisco Network Convergence System 4000 Series Unpacking, Moving and Securing Guide
1
C H A P T E R
1