Identifying Drop-Cables - Honeywell EXPERION PKS Installation Manual

Chapter 4 - ControlNet Network Component Installation
Through Body Hole Mounting
4.2.3

Identifying drop-cables

ATTENTION
If you have not already done so, this is a good time to apply identification to your drop-cables. For
more information regarding drop-cable identification, refer to the Planning Guide, ControlNet
Configuration, Planning Your Taps, Planning for drop-cable identification
Identifying the drop-cables from the taps you install makes locating system parts and troubleshooting
the system much easier. Drop-cable labels are included with each tap kit.
CAUTION
Do not over-tighten the screws. Doing so can damage the tap. Applied torque should be
0.2-0.4 N•M (1-2 ft-lbs.).
- 19 -