New Test File - GE ALPS Instruction Manual

10.3 FILE MENU
10.3 FILE MENU
The File menu is shown below:
Select New Test File from the File menu. This will create a new test which is indicated by the GE logo being displayed and
the test name "Untitledx" in the title bar. The 'x' is a digit corresponding to the number of new documents created.
This menu item results in a dialog box supplied by Microsoft. Therefore only the OK button of the dialog box is tested to
make sure the file was properly opened.
Select Open Test File from the File menu. Select a file that is not a test file and not a setting file. A message box is dis-
played that explains the error. Verify that the currently active test has not changed from before the open command.
Edit an existing test file using a text editor. Add a line to the file. Select Open Test File from the File menu. Select the
edited file. A message box is displayed that explains the error. Verify that the currently active test has not changed from
before the open command.
Edit an existing test file using a text editor. Remove a line which contains a user entered value that is not a default value.
Select Open test File from the File menu. Select the edited file. A message box is displayed explaining the error. Verify
that the test file is still loaded and that the missing value has its default value.
Select Open Test File from the File menu. Select a test file containing no errors and click the OK button to open it. Select
a test. Verify that the values in the dialog box are the same as those in the file (see the Save Input Quantities section).
The following is a list of protection setting numbers whose values are used by this test program.
102 Z1PREACH
105 Z1GRDREACH
108 Z1GROUNDK0
202 Z2PHREACH
203 Z2PCHARANG
206 Z2GRDREACH
207 Z2GCHARANG
302 Z3PHREACH
303 Z3PCHARANG
305 Z3GRDREACH
306 Z3GCHARANG
402 Z4PHREACH
403 Z4PCHARANG
406 Z4GRDREACH
10
407 Z4GCHARANG
408 Z4DIRECTN
10-8
Figure 10–13: FILE MENU
Z1 Phase Reach
Z1 Ground Reach
Z1 Ground K0
Z2 Phase Reach
Z2 Phase Characteristic Angle
Z2 Ground Reach
Z2 Ground Characteristic Angle
Z3 Phase Reach
Z3 Phase Characteristic Angle
Z3 Ground Reach
Z3 Ground Characteristic Angle
Z4 Phase Reach
Z4 Phase Characteristic Angle
Z4 Ground Reach
Z4 Ground Characteristic Angle
Z4 Direction
ALPS Advanced Line Protection System
10 ALPS TEST PROGRAM

10.3.1 NEW TEST FILE

10.3.2 OPEN TEST FILE
10.3.3 OPEN SETTING FILE
GE Power Management