Reset The Satellite To Factory Defaults; About Link Aggregation - NETGEAR Orbi Pro Ceiling Satellite User Manual

The Connected Devices page displays. For each device, the page displays the IP
address, device name, MAC address, and connection type.

Reset the satellite to factory defaults

Under some circumstances (for example, you move the satellite to a different network),
you might want to erase the configuration and reset the satellite to factory default
settings.
After you reset the satellite to factory default settings, the WiFi network name (SSID)
and network key (password) are as shown on the satellite label (Satellite label on page
10). For a more extensive list of factory default settings, see Factory settings on page
37.
To reset the satellite to factory defaults:
1. On the back panel of the satellite, locate the recessed Reset button.
For more information, see Hardware overview on page 7.
2. Using a straightened paper clip, press and hold the Reset button for about 10
seconds.
3. Release the Reset button.
The configuration is reset to factory default settings. When the reset is complete,
the satellite reboots. This process takes about two minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset.
Do not turn off the satellite. Wait until the satellite finishes restarting and the Power
LED turns solid green.

About link aggregation

For a link aggregation (LAG) connection, you must use a switch that supports link
aggregation. You can make a link aggregation connection between the satellite and a
switch that supports an 802.3ad link aggregation group (LAG) or static link aggregation.
Such a LAG connection allows for a single 2 Gbps connection for increased throughput
or a 1 Gbps redundancy connection.
By default, both PoE+ LAN 1 port and LAN 2 port are enabled on the satellite. The LAN 2
port is the LAG connection port, required for a LAG connection. Link aggregation is
enabled by default on the satellite, so you do not have to configure it. However, you
must configure link aggregation on the switch.
Manage Your Orbi Pro Ceiling
Satellite
Orbi Pro Ceiling Satellite
28 User Manual