Table Of Contents - Makita LS1216 Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Blade case section, Motor section (cont.)
DISASSEMBLING
(8) Loosen M6x16 H. S. set screw (flat point) slightly to remove
Rod 16 in the next step.
Loosen M6x20 Hex socket head bolt to make the spring force
of Torsion spring 40 ineffective. (Fig. 9)
(9) After Spring force becomes ineffective, strike Rod 16 from
Knob 20 side as drawn in Fig. 10.
Note: Do not strike Rod 15 from the opposite of Knob 20 side.
The way increases the possibility that the scratched spot
by M6x16 H. S. set screw get caught in the hinge portion.
Rod 16 can be removed from the hinge portion.
(10) Pull Knob 20 to unlock Blade case complete
and remove Blade case section from Front
arm complete. (Fig. 11)
(11) Loosen two M4x10 Pan head screws.
Guard section can be removed. (Fig. 12)
(12) Remove Stop ring E-5 from Link shaft (that is
a component of Blade case complete).
Link plate and Ring 6 can be removed.
(Fig. 13)
Fig. 11
Blade
case
section
Front arm
complete
Torsion
spring 40
Fig. 13
Ring 6
Link plate
Fig. 10
Rod 16
Front arm complete
Blade case section
Fig. 12
Guard section
Knob 20
M4x10 Pan head screw(2pcs.)
Link shaft
Stop ring E-5
Flat washer 6
Fig. 9
M6x16 H. S. set screw (flat point)
for pressing Rod 16
M6x20 Hex
socket head bolt
for pressing Torsion
spring 40
Spring washer 6
the scratched spot on Rod 16
782223-9 or less than
ø16mm rod
P 7/ 35
Knob 20