Blade - Makita LS1216 Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-4. Safety cover A
ASSEMBLING
(1) Assemble Safety cover A section. (Fig. 42) And then mount the Safety cover A section to Safety cover B. (Fig. 43)
(2) Mount the Safety cover section to Blade case complete as illustrated in Fig. 44.
Fig. 42
After applying grease to Torsion
spring 45 as drawn in Fig. 2, set
the ends to Safety cover A.
The legs of Torsion
spring 45
Safety cover A
Fig. 43
Mount Safety cover A section to
Safety cover B by tightening
three Bind CT4x12 Tapping screws.
Fig. 44
Tighten M8x12 Hex flange head bolt and lift up
Center cover until it touches the bolt.
M8x12 Hex flange
head bolt
Fit the five bosses of Safety cover A
into the five holes of Center washer.
Five bosses
Apply Grease to the outer periphery
of Center washer that contacts Center
cover A.
Center cover
Safety cover A
Center cover
Set Center cover in place and fit the five
bosses of Safety cover A into the five holes
of Center plate. Then fasten them by
tightening CT4x16 Tapping screw.
Center plate
Center
washer
Bind CT4x12
Tapping
screw (3pcs.)
Safety cover B
Tighten Hex flange head bolt firmly to fix Center cover
at the position designated below.
P 14/ 35
CT4x16
Tapping screw
Center
cover
M8x12 Hex
flange
head bolt