Spring Washer - Makita LS1216 Technical Information

R
epair
Note: Remove Saw blade and Safety cover section before disassembling.
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Blade case section, Motor section
DISASSEMBLING
1) Push Knob 20 to hook Stopper pin with Blade case complete
kept in its upper dead point. (Fig. 4)
2) Loosen two Bind CT4x12 Tapping screws, then remove
Strain relief. (Fig. 4)
3) Remove M6x20 Hex socket head bolt.
Link plate can be removed from Front arm complete. (Fig. 5)
4) Remove M5x18 Hex socket head bolt and Sleeve 6. (Fig. 6)
Note: Press Sleeve 6 against the rib of Blade case complete
to keep their contact as drawn in Fig. 6 when tightening
M5x18 Hex socket head bolt in reassembling step.
5) While holding Blade case complete with hand against spring force,
pull Knob 20 and move Blade case complete slowly and carefully
to vertical position to Turn base. (Fig. 7)
6) Push Knob 20 to hook Stopper pin with Blade case complete at
the vertical position. (Fig. 7)
7) Loosen M6x16 H. S. set screw (flat point) slightly to remove
Rod 16 in the next step.
Loosen M6x20 Hex socket head bolt to make the spring force of
Torsion spring 40 ineffective.
Note: Do not remove M6x20 Hex socket head bolt completely.
Fig. 6
Sleeve 6
M5x18 Hex socket
head bolt
Fig. 7
Blade case complete
Torsion spring 40
Rib of Blade case complete
Sleeve 6
M5x18 Hex socket head bolt
Rib of Blade case complete
Knob 20
Fig. 4
Knob 20
Stopper pin
Blade case complete
at the upper dead
point
Fig. 5
Front Link plate
arm
complete
Ring 6
Fig. 8
Blade case complete
at upper dead point
M6x20 Hex socket head
bolt for pressing one leg
of Torsion spring 40
Knob 20

Spring washer 6

M6x16 H. S. set screw
(flat point) for holding
Rod 16
P 6/ 35
Strain relief with
Bind CT4x12
Tapping screw
(2pcs each.)
M6x20 Hex
socket head
bolt
Flat washer 6