Section - Makita LS1216 Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-5. Turn Base, Base
DISASSEMBLING
(1) Remove Fence section, Kerf board and Miter scale plate from Turn base and Base. (Fig. 45)
(2) Remove Turn base section from Base. (Fig. 46)
Fig. 45
1. Remove Upper fence, Lower
fence, Guide fence and Kerf
board.
Lever 45 (2pcs.)
Upper fence (2pcs.)
Lower fence (2pcs.)
Guide fence
Fig. 46
Remove M8x45 Hex bolt with
Socket wrench 13.
And remove Flat washer 8.
ASSEMBLING
Take the disassembling step in reverse. (Figs. 46 and 45)
Note: Apply Grease to Slide plate and the center hole of Base before assembling Turn base section. (Refer to Fig. 3.)
Tighten M8x45 Hex bolt so that Turn base section can turns smoothly without wobbling.
2. Turning Grip 50 clockwise at
90 degrees, move Turn base to
the direction designated with
black arrow until it stops.
Kerf board
Grip 50
Turn base

section

M8x45 Hex bolt
Flat washer 8
3. Remove Miter scale plate from Base by
unscrewing 4x12 Tapping screws (3pcs.)
Base
Miter scale plate
Lock lever
While pressing down Lock
lever, remove Turn base
section from Base.
P 15/ 35