Stop Ring E- - Makita LS1216 Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-3. Lock Lever Section (exclusively for the specifications with Locking mechanism of Blade
case complete at the upper dead point)
DISASSEMBLING
1) Remove two M4x10 Hex socket head bolts and two Flat washers 4, then remove Lock lever and Torsion spring 8. (Fig. 38)
2) Remove two CT4x16 Tapping screws and separate Rod 8 from Rod holder. (Fig. 39)
Fig. 38
Lock lever
Flat
washer 4
(2pcs.)
Torsion spring 8
ASSEMBLING
Take the reverse step of disassembling.
(1) Press Rod holder against the rib of Blade case complete and secure Rod holder by tightening two CT4x16 Tapping
screws.
(2) When assembling Lock lever to Rod 8;
• Pass Rod 8 through Torsion spring 8 and insert the one end of Torsion spring 8 into the hole of Rod holder.
• Hook the other end of Torsion spring 8 with the reverse of Lock lever and align Lock lever with the step of
Rod 8 by tightening two M4x10 Hex socket head bolts and CT4x16 Tapping screws (2pcs.). (Figs. 39, 40)
• Adjust the clearance between Lock lever and Safety cover B to 2mm up to 3mm height by sliding Lock lever.
(Fig. 41)
Fig. 40
Viewed from Rod holder
Step of Rod 8 to
align Lock lever
The other end of
Torsion spring 8
M4x10 Hex
socket head
bolt (2pcs.)
One end of
Torsion spring 8
Hole of
Rod holder
Blade case
complete
Rod 8
Fig. 39
Rod holder

Stop ring E-6

Torsion
spring 8
Blade case
complete
Fig. 41
Lock lever
Safety cover B
CT4x16 Tapping
screws (2pcs.)
Rod 8
Lock lever
2mm up to 3mm
P 13/ 35
M4x10 Hex
socket head
bolt (2pcs.)
Flat washer 4
(2pcs.)