Table 15 Antenna Replacement Procedure - Honeywell OneWireless XYR 6000 User Manual

6. Maintenance/Repair
6.4. Replacing antenna
Step
Honeywell recommends that the transmitter be removed from service and moved to a clean
1
area before servicing.
Loosen the M3 locking set screw on the display end-cap. See item 1 in Figure 10. Unscrew
2
and remove the front end cap.
Loosen the two screws on the sensor module. See items 2 in Figure 10.
3
Remove the sensor module from the transmitter body and disconnect the antenna connector
4
from CN2 connector on the sensor module. See item 3 in Figure 10.
Loosen the locking set screw at the antenna base. Unscrew the antenna from the transmitter.
5
Remove the antenna and its connector from the transmitter. See Figure 10.
Feed the new antenna's connector through the antenna hole to the front of the transmitter. Do
6
not connect to sensor module yet. Lubricate with Silicone Grease such as Dow Corning #55.
Screw new antenna into transmitter body until finger-tight, then back off 180 degrees to permit
adjustment later.
Attach antenna connector to CN2 connector on sensor module. See item 3 in Figure 10.
7
Insert sensor module. Orient in the proper viewing orientation before tightening two sensor
8
compartment screws. See items 2 in Figure 10. Torque screws to 0,4 – 0,6 N-M (3.5 – 5.3 Lb-
in).
Replace the front end cap. Honeywell recommends lubricating the front end cap O-ring with a
9
Silicone Grease such as Dow Corning #55 or equivalent before replacing the end cap.
Adjust antenna for best reception. Don't rotate antenna more than 180 degrees either direction
10
or you could twist and break the antenna wiring inside. Tighten the antenna locking set screw.
42 OneWireless XYR 6000 Temperature and Temperature/Discrete Input Transmitter User's Manual

Table 15 Antenna replacement procedure

Action
Rev. 3
6/24/08