Table 13 Battery Replacement Procedure; Figure 8 Battery Replacement - Honeywell OneWireless XYR 6000 User Manual

6. Maintenance/Repair
6.2. Replacing batteries
Step
ATTENTION
You must replace both batteries. Both batteries must be the same model from the same
manufacturer. Mixing old and new batteries or different manufacturers is not permitted.
Use only the following 3.6V lithium thionyl chloride (Li-SOCl2) batteries (non-rechargeable),
size D. No other batteries are approved for use in XYR 6000 Wireless Transmitters.
•
•
•
•
•
•
Loosen the M3 locking set screw on the battery end-cap (opposite end from display). See item
1
1 in Figure 8. Unscrew and remove the end cap.
Using thumb and forefinger, squeeze the battery connector at top and bottom to disengage the
2
locking mechanism, then pull to disconnect. See item 2 in Figure 8.
Loosen the two battery holder retaining screws (closest to the batteries). See item 3 in Figure
3
8. The screws are captive.
Pull the battery holder out of the transmitter.
4
Remove the old batteries from the battery holder. If needed, pry out the batteries by using a
5
slotted screwdriver as a lever in the holder's side slots. See item 4 in Figure 8.
38 OneWireless XYR 6000 Temperature and Temperature/Discrete Input Transmitter User's Manual
+
4

Figure 8 Battery replacement

Table 13 Battery replacement procedure

Xeno Energy XL-205F
Eagle Picher PT-2300H
Tadiran TL-5930/s
Honeywell p/n 50026010-001 (Two 3.6V lithium thionyl chloride batteries) (1 transmitter)
Honeywell p/n 50026010-002 (Four 3.6V lithium thionyl chloride batteries) (2 transmitters)
Honeywell p/n 50026010-003 (Ten 3.6V lithium thionyl chloride batteries) (5 transmitters)
-
+
3
-
2
Action
1
Rev. 3
6/24/08