Installing/Removing Headstock Center - Grizzly G0766 Owner's Manual

Headstock Center
Installing/Removing
Headstock Center
The included spur center installs in the headstock
spindle with an MT#2 tapered fit.
Installing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Make sure mating surfaces of center and
spindle are free of debris and oily substances
before inserting center to ensure a good fit
and reduce runout.
3.
Insert tapered end of center into spindle, and
push it in with a quick, firm motion, as shown
in Figure 19.
Figure 19. Installing center in headstock spindle.
-24-
4. Make sure center is securely installed by
attempting to pull it out by hand—a properly
installed center will not pull out easily.
Removing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Hold a clean rag under spindle or wear leath-
er glove to catch center when you remove it.
3.
Insert knockout tool through outbound end of
spindle and firmly tap back of center, catch-
ing it as it falls, as shown in Figure 20.
Knockout Tool
Figure 20. Removing the headstock center.
Model G0766 (Mfd. Since 11/17)