Installing/Removing Headstock Center - Grizzly T32536 Owner's Manual

Installing/Removing
Headstock Center
The included spur center installs in the headstock
spindle with an MT#1 tapered fit.
Items Needed
Knockout Tool .................................................... 1
Heavy Leather Gloves ................................1 Pair
Clean Rags ........................................ As Needed
Installing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Make sure mating surfaces of center and
spindle are free of debris and oily substances
before inserting center to ensure a good fit
and reduce runout.
3. Insert tapered end of center into spindle, and
push it in with a quick, firm motion, as shown
in Figure 14.
Figure 14. Installing center in headstock spindle.
4. Make sure center is securely installed by
attempting to pull it out by hand. A properly
installed center will not pull out easily.
-20-
Qty
Headstock Center
Spindle
Removing Headstock Center
1.
DISCONNECT MACHINE FROM POWER!
2.
Hold a clean rag under spindle or wear leath-
er glove to catch center when you remove it.
3.
Insert knockout tool through outboard end of
spindle and firmly tap back of center, catch-
ing it as it falls, as shown in Figure 15.
Knockout Tool
Figure 15. Removing headstock center with
knockout tool.
Model T32536 (Mfd. Since 10/20)
Spur
Center