Table of Contents
Advertisement
To outboard turn:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove tailstock and tool base from machine
by removing hex nuts and clamp washers
located underneath assemblies, then lifting
them from lathe bed.
3.
Loosen headstock, then move it all the way to
tail end of lathe bed, as shown in Figure 39.
Figure 39. Example of lathe prepared for
outboard turning.
4.
Re-tighten headstock to bed.
When outboard turning, ALWAYS use a
floor-mounted tool rest and keep tool in
contact with rest during all turning opera-
tions. Failure to do so could cause tool to be
pulled out of operator's control and ejected
at high speed.
-32-
Sanding/Finishing
After the turning operations are complete, the
workpiece can be sanded and finished before
removing it from the lathe, as shown in Figure 40.
Figure 40. Typical sanding operation.
Note: Whenever sanding or finishing, move tool
rest holder out of the way to increase personal
safety and gain adequate working room.
Sandpaper
Wrapping
per completely around
workpiece
your hands into mov-
ing workpiece and may
cause
Never
per or finishing materi-
Workpiece
als completely around
workpiece.
Model G0766 (Mfd. Since 11/17)
sandpa-
could
pull
serious
injury.
wrap
sandpa-
Advertisement
Table of Contents
