Audio Test; Led Test; Calibration Test - Honeywell Galaxy TouchCenter Plus Installer Manual

Audio Test

Perform the audio test as follows:
ICON
1. On the Home
then enter an authorised code.
2. Press the System Setup
3. Press the
Advanced Setup
4. Press the
Keypad Test
5. Press the Audio Test
beeps sound from the speaker.

LED Test

Perform the LED Test as follows:
ICON
1. On the
Home
then enter an authorised code.
2. Press the System Setup
3. Press the
Advanced Setup
4. Press the
Keypad Test
5. Press the LED Test icon.
while the 3 LEDs light sequentially, top to bottom
(red, green, yellow), 5 times.

Calibration Test

If the Touch Screen requires recalibration, do the following:
ICON
1. On the
Home
then enter an authorised code.
2. Press the
System Setup
3. Press the Advanced Setup
4. Press the
Keypad Test
5. Press the
Calibration
follow the screen directions by pressing a series of
crosshairs (+) and boxes () on the screen until
done.
6. If the test was successful, press
returns to the
User System Setup (cont'd)
ACTION
screen, press the Setup icon, and
icon.
icon.
icon.
icon. Testing is displayed as
ACTION
screen, press the icon, and
Setup
icon.
icon.
icon.
Testing is displayed
ACTION
screen, press the icon, and
Setup
icon.
icon.
icon.
icon and using a stylus,
. The screen
OK
screen.
Keypad Test
If you press Yes, Passed is displayed on the
test screen.
If you press No, Failed is displayed in the test
screen.
At the conclusion of the test, a popup displays:
Did you see chasing LED pattern?
If you press Yes, Passed is displayed on the
test screen.
If you press No, Failed is displayed in the test
screen.
A popup message displays:
Touch screen calibration
Touch crosshair to calibrate
If the Calibration test was successful, a
confirmation screen appears stating:
Calibration Success
If the test was unsuccessful, an error message
appears stating:
Calibration Failure:
Retry, Ignore, Cancel.
25
NOTES
NOTES
NOTES