Initial Setup; Initial Power Application - Honeywell Galaxy TouchCenter Plus Installer Manual

Initial Power Application

When initially powered, the screen displays
ACTION
1. Apply power to the panel, which also powers
the Galaxy TouchCenter Plus.
Plus is displayed along with the loading
progress indicator bar. This is then followed by
the
Set RS485 Address
2. On the Set RS485 Address
the following:
a) Leave the default address unchanged (the
default address is 0).
b) Use the up/down arrows to select a new
address if 0 is used by another device on the
panel.
3. Press .
OK
4. On the next screen, select the required language
and, if not required, deselect
is selected by default).
5. Click . The
OK Home
6. To set the time and date refer to Time/Date
Setup.

Initial Setup

TouchCenter Plus
TouchCenter
screen.
screen, do one of
(it
EN50131 Mode
screen is displayed.
and the loading progress indicator bar.
NOTES
Note: The Galaxy TouchCenter Plus has been calibrated at
the factory. If the screen requires recalibration, the end user
may do so via the Keypad Test screen. See the LCD
Display Test section for instructions.
10