Snmp Configuration Capability - Cisco Prisma II Installation And Operation Manual

Forward and reverse headend driver amplifiers
Hide thumbs Also See for Prisma II:
Table of Contents

Advertisement

SNMP Configuration Capability

Introduction
The IP Setup menu item in the ICIM menu allows you to enter an IP address, IP
subnet, and gateway IP in order to configure the ICIM for remote status monitoring
and control by an Simple Network Management Protocol (SNMP) network
management system.
Note: Contact Cisco Services for MIB files.
SNMP Considerations
The following items should be considered when implementing SNMP:
• The SNMP connection is made through the Ethernet port on the front of the ICIM.
(Use 10baseT cable with an RJ-45 connector.) In order to meet the requirements of
GR-1089-CORE, a shielded cable must be used and both ends must be grounded.
• The Network Management System (NMS) must be installed behind a firewall to
prevent any ill-intentioned persons with an SNMP manager from accessing, and
tampering with, the ICIM.
• When the ICIM has to handle excessive SNMP traffic, it will respond slowly to
both SNMP control and front panel input. If this occurs, reduce the update rate of
the SNMP manager.
Important: If an HDRX chassis is set to chassis ID 41, the ICIM will not detect
receiver 9 in that chassis.
Basic SNMP Setup
Refer to your SNMP manager documentation and/or Management Information Base
(MIB) information for instructions on implementing SNMP. Before you can use and
reconfigure SNMP services, you need to know the community names in your
network and the IP addresses or computer names for SNMP management hosts that
traps are sent to.
Setting Up the IP Configuration Parameters for SNMP Support
Follow these steps to set up the IP configuration parameters.
1.
Press the
Result: The ICIM menu displays.
2.
Select the Password menu and enter the User Password.
Result: The ICIM allows configuration changes for the next 10 minutes.
Note: Refer to your specific hardware Installation and Operation Guide for
more information on using, entering, or changing the ICIM user password.
3-32
key.
ICIM
Operation Using ICIM
78-4006323-01 Rev C

Advertisement

Table of Contents
loading

Table of Contents