Operating The Icim - Cisco Prisma II Installation And Operation Manual

Operating the ICIM

Using the ICIM
Once the module is installed as described in Chapter 2, it runs without the aid of an
operator. Unless alarms are generated or your system configuration changes, you
should not need to make any adjustments to the module beyond the initial setup.
Accessing the ICIM LCD Contrast
To access the ICIM LCD contrast control from the MAIN menu, press the
Use the

The MAIN Menu
A few seconds after power-up, the MAIN menu (shown below) is displayed. Press
the key to select the specific option.
SEL
Display
Offline
Modules
Alarms
Scroll
Module
Shelf
Slot
78-4006323-01 Rev C
key to increase or the
Indicates TNCS communication status with the ICIM.
Indicates the number of modules in the ICIM domain.
Displays the number of modules that are in alarm. Selecting this
option allows scrolling through all modules in alarm condition.
Allows scrolling through all modules in the ICIM domain.
Allows selection of any specific module in the ICIM domain.
Operation Using ICIM
key to decrease ICIM display contrast.
Description
key.
ICIM
3-13