Connecting The Cables To The Chassis - Cisco Prisma II Installation And Operation Manual

Connecting the Cables to the Chassis

RF Cable Connection Procedure
Important: The following procedure assumes the Prisma II Chassis is mounted in a
rack.
Follow this procedure to make the RF cable connections for each module to be
installed. This module is usually installed in slots five through sixteen.
1. Locate one 75 ohm RF cable and route it to the appropriate RF destination.
2. At the rear of the Prisma II Chassis, attach the other end of the RF source
cable to Port A (RF Input) of the slot where the module is to be installed. This
is the RF input connection.
3. Connect another RF cable from Port B (RF Output) of the slot where the
HEDA is to be installed. Hand-tighten the connector.
4. Route the RF cable from Port B (RF Output) to the appropriate destination.
5. If F-connectors are installed, use a 7/16-in. open-end wrench to secure both
cables to the connectors at the chassis. If BNC connectors are used, twist
firmly to connect.
2-6 Installation 78-4006323-01 Rev C